Details Of Status Messages And Treatment Method - Epson AcuLaser C1900 Service Manual

EPSON AcuLaser C1900/AcuLaser C900

3.3.3 Details of Status Messages and Treatment Method

RESETTING PRINTER (STATUS CODE: 1004)
Description
The printer is being reset. This status occurs when EEPROM is cleared. It is not
caused by operations by the user.
SETTING DEVELOPER CARTRIDGE POSITION (STATUS CODE: 1019)
Description
The toner to replace (during change toner) is moving to the defined position.
Treatment method.
The display is changed to "Replace Toner uuuu" when the toner arrives at the
defined position.
WARMING UP (STATUS CODE: 1006)
Description
The printer is warming up.
Treatment method
The printer recovers automatically within 180 seconds.
ADJUSTING PRINT FUNCTION (STATUS CODE: 1014)
Description
The printer engine is being adjusted.
This is performed automatically in the following cases.
When a consumable is replaced
When the cover is opened and closed not because of paper jam
(mode to enforce AIDC)
When the printer is turned on after more than 200 sheets from last AIDC or
after recovering from the standby status
When the printer is turned on after more than 1000 sheets from the picture
stabilization control or after recovering from the standby status.
Troubleshooting
COOLING DOWN (STATUS CODE: 1016)
Description
The printer engine is cooling down.
Internal temperature is too high to print transparencies. In this case, the print stops
until the internal temperature becomes suitable for printing transparencies.
Treatment method
The printer becomes ready automatically after approximately one minute, and then
it resumes printing.
POWER SAVING MODE (STATUS CODE: 1007)
Description
The printer is in the sleep mode.
Treatment method
The printer recovers and becomes ready to print after receiving print data.
READY (STATUS CODE: 1000)
Description
The printer is in the normal state.
PRINTING (STATUS CODE: 1002)
Description
The printer is processing the print job.
PRINTING (STATUS CODE: 1009)
Description
The printer is printing.
PRINTING DATA FROM ANOTHER PORT (STATUS CODE: 1012)
Description
Printing is in progress via the other interface.
Treatment method
The printing starts automatically after finishing the current job.
Status Display (AcuLaser C900)
Revision B
152