Epson AcuLaser C1900 Service Manual page 155

EPSON AcuLaser C1900/AcuLaser C900
INCORRECT PAPER SIZE (STATUS CODE: 3003)
Description
Since the paper size specified by the print data differs from the paper size
recognized by the size detection method of the Paper Source setting, the operation
stops before printing starts.
The Continue command of the ESCPAGES-02 protocol clears the error, and
printing resumes. The ResetPrinter command clears the error in the printer engine,
resetting the printer to its initial status.
This error does not occur when the specified paper size is an undefined paper size,
and when "Size Ignore = ON" and "Avoid Error = ON" are selected.
Remedy
Insert the appropriate paper, and then select [Continue] in the EPSON Status
Monitor.
To reprint after modifying driver settings, select [Cancel Printing] in the EPSON
Status Monitor.
INCORRECT PAPER SIZE (STATUS CODE: 3002)
Description
If paper larger than A4/LT (such as A3) is specified, or a different feeding
direction is selected (such as A4 Long Edge Feed), the operation stops before
printing starts.
The Continue command of the ESCPAGES-02 protocol clears the error, and
printing resumes.
When "Avoid Error = ON" is set, the printer displays the "Print Failure" error
status instead of this error, and resumes printing from the next page.
Remedy
To print pages after "Invalid Size", select [Continue] in the EPSON Status
Monitor.
To reprint after modifying the driver settings, select [Cancel Printing] in the
EPSON Status Monitor.
Since the printer driver clips data to the A4 paper size, this error does not occur in
practice.
Troubleshooting
PAGE CONTAINS TOO MUCH DATA TO PROCESS (STATUS CODE: 3000)
Description
The print data has cut off in document processing, and the printer starts printing in
timeout. However, the band data is insufficient.
Printing does not succeed because data configuring the band for printing is not
completely received when printing flying starts, or the memory is insufficient for a
flying start due to "Near Buffer Full".
Resetting the printer to its initial state by the ResetPrinter command of the
ESCPAGES-02 protocol clears the error.
Remedy
If data is not completely received, selecting [Reprint] in the EPSON Status
Monitor may allow successful printing in some cases; as a result the driver resends
data without a flying start.
To reprint after modifying driver settings, select [Cancel Printing] in the EPSON
Status Monitor.
INSUFFICIENT PRINTER MEMORY (STATUS CODE: 3001)
Description
Because of insufficient memory, data for one page is not saved.
The Continue command of the ESCPAGES-02 protocol clears the error, and
printing resumes from the next page.
When "Avoid Error = ON" is set, the printer displays the "Print Failure" error
status instead of this error, and resumes printing from the next page.
Remedy
To print pages after the memory error, select [Continue] in the EPSON Status
Monitor.
To reprint after modifying the driver settings, select [Cancel Printing] in the
EPSON Status Monitor.
Status Display (AcuLaser C900)
Revision B
155