EPSON AcuLaser C1900/AcuLaser C900
4.7.3 Reverse Motor / Transfer Motor
1.
Separate the Duplex Unit from the Printer.
2.
Remove the Board Protection Cover.
3.
Disconnect the connector (PJ1) from the Duplex Unit Control Board (PWB-A).
4.
Remove the cover of the Duplex Unit (1 screw) and then remove the wires from the
code folder.
(See "Figure 4-67 (p.207)")
5.
Remove the Reverse Motor and the Transfer Motor. (4 screws)
(See "Figure 4-68 (p.207)")
Disassembly and Assembly
Duplex Unit Disassembly and Assembly
Figure 4-67. Cover (Duplex Cover) Removal
Figure 4-68. Reverse Motor / Transfer Motor Removal
Revision B
207