Epson AcuLaser C1900 Service Manual page 50

EPSON AcuLaser C1900/AcuLaser C900
Table 1-36. Function Setting (2)
Menu Item
Emulation Menu Parallel
USB
Network
AUX *2
Printing Menu Page Size
Wide A4
Orientation
Resolution
RITech
Toner Save
Image Optimum
Top Offset
LeftOffset
T Offset B *4
L Offset B *4
Setup Menu Lang
Lang
Sprache
LINGUA
LENG
SPRAK
Sprog
Taal
KIELI
Ling.
Time Out
Paper Source
MP Mode
Manual Feed
Product Description
Value
Auto, LJ4, ESCP2, FX, I239X, PS3 *1 , GL2
*1
Auto, LJ4, ESCP2, FX, I239X, PS3 , GL2
Auto, LJ4, ESCP2, FX, I239X, PS3 *1 , GL2
Auto, LJ4, ESCP2, FX, I239X, PS3 *1 , GL2
*3 *3
A4 , A5, B5, LT , HLT, GLT, EXE, MON,
C10, DL, C5, C6, IB5, CTM *5
Off, On
Port, Land
600, 300
On, Off
Off, On
Auto, Off, On
-99.0 ~ 0.0 ~ 99.0 mm step 0.5 mm
-99.0 ~ 0.0 ~ 99.0 mm step 0.5 mm
-99.0 ~ 0.0 ~ 99.0 mm step 0.5 mm
-99.0 ~ 0.0 ~ 99.0 mm step 0.5 mm
English
Francais
Deutsch
ITALIANO
ESPANOL
SVENSKA
Dansk
Nederl.
SUOMI
Portugues
0, 5 ~ 60 ~ 300 step 1
Auto, MP, LC *6
Normal, Last
Off, On
Table 1-36. Function Setting (2) (continued)
Menu
Setup Menu Copies
Quantity
Duplex *8
Binding
Start Page
Paper Type
Page Side
Skip Blank Page
Auto Eject Page
Size Ignore
Auto Cont
Page Protect
Toner Out
LCD Contrast
Panel Lock
Note *1: Displayed only when the optional PostScript3 module is installed
*2: Displayed only when a Type-B interface card is installed
*3: Depending on the default paper size of the controller configuration when shipped
from the factory
*4: Displayed only when the optional Duplex Print Unit is installed
*5: For CTM (user defined) paper size (width x height), the minimum is 92 x 148 mm
and the maximum is 216 x 297 mm.
*6: Displayed only when the optional Cassette Unit is installed
*7: Not displayed on the panel, and not included in the Status sheet either. Possible to be
set at EJL or PJL. Not stored in NVRAM.
*8: Displayed only when the optional Duplex Print Unit is installed
*9: Valid in the ESC/Page, PCL5e, ESCP2, FX, and I239X modes
*10: Not displayed on the panel, and not included in the Status sheet either. Possible to be
set at JL.
*11: Set "Back" when print on the backside of the manual duplex printing.
*12: Even if the toner out occurs, Replace Toner xxxx error will not occur when "Toner
Out = Continue". As a result, the continuous printing is possible but in this case, the
print quality is not guaranteed. Note when this setting is used with Continue.
Control Panel
Item Value
1 - 999
*7 1 - 999
Off, On
*8
Long Edge, Short Edge
*8 Front, Back
Normal, Thick, Envelope, Trnsprnc, Coated
*11
Front, Back
*9 Off, On
Off, On
Off, On
Off, On
Auto, On
*9
Stop, Continue
0 - 7 - 15
*10 Off, On
Revision B
50