Epson AcuLaser C1900 Service Manual page 61

EPSON AcuLaser C1900/AcuLaser C900
Duplex Printing
Select Simplex printing or Duplex printing.
Permit Duplex printing only when the paper size is A4 or LT. With any other
paper size, the selection of Duplex printing is invalid, displaying the error message
"Can't print duplex".
NOTE: The driver also provides the ability to cancel Duplex printing in the
paper size and paper type settings.
RITech
The RITech function can be enabled or disabled in the RITech setting.
Toner Save
Select whether the Toner Save function is enabled or disabled.
Top Offset
Set the print starting vertical position on a sheet.
NOTE: The printer permits the setting in the range of about -30.0 ~ 30.0 mm in
1-dot increments, while the setting by the driver is limited to - 9 ~ 9mm in
1-millimeter increments.
Binding margins for Duplex printing with the Top Offset setting value are
limited to 0 ~ 30 mm in 1-millimeter increments.
Left Offset
Set the print starting horizontal position on a sheet.
NOTE: The printer permits the setting in the range of about - 30.0 ~ 30.0 mm in
1-dot increments, while the setting by the driver is limited to - 9 ~ 9 mm in
1-millimeter increments.
Binding margins for Duplex printing with the Top Offset setting value are
limited to 0 ~ 30 mm in 1-millimeter increments.
Paper Type
Printing speed, fuser temperature and other necessary settings are determined for
the paper type for use.
When the paper type is Envelope, an envelope is printed using an undefined paper
size. Printing becomes 2/3 faster than the Thick paper setting.
Product Description
Page Side
In the manual duplex printing mode, this setting determines whether to use the side
of a sheet being printed first (Front) or the opposite side to the already printed side
(Back).
NOTE: The user must be advised to select the paper side in combination with
paper types. This setting is required at printing on thick paper, coated
paper or postcards. For printing on a postcard (back side), set
"postcard" or "double postcard" as the paper size, "plain paper" as the
paper type and "back" as the paper side.
Size Ignore
Select whether or not to ignore the errors "Paper Set" and "Check Paper Size".
Avoid Error
Select whether or not to avoid occurrence of any of the followings: "Paper Set",
"Invalid Size", "Mem Overflow", "Duplex Mem Overflow"
ON: The printer continues printing without displaying any of the above
errors. "Paper Set" does not occur, but "Check Paper Size" appears if
the paper size of the fed sheet is not as designated. None of "Invalid
Size", "Mem Overflow", and "Duplex Mem Overflow" occurs, but
"Print Failure" appears.
OFF: Once any of the aforementioned errors occur, the printer will not
recover until receiving a release command through the ESCPAGES-
02 protocol.
"Avoid Error" is intended not to suspend the printer for a long time such condition that
the printer is not monitored sufficiently, for example, in the case of printing with the
printer used as a shared printer.
Control Panel
Revision B
61