Epson AcuLaser C1900 Service Manual page 136

EPSON AcuLaser C1900/AcuLaser C900
JAM XXXX (STATUS CODE: 4008, 4009, 4017)
Panel Status Code
x = A 4009
x = B 4008
x = C 4009
x = DM 4017
Note : Multiple jams may occur at the same time; in this case. JAM A B C DM or a similar
message appears.In this case priority of Status Code is, 4008 > 4009 > 4017.
Troubleshooting
Table 3-20.
Meaning
Jam occurs at the MP Tray.
Open the Cover AB and pull down movable
transportation guide (under) and pulled out jammed
paper and close the Cover AB. After this, this error
will clear automatically.
Jam occurs at the second transfer unit, fuser unit or
paper exiting unit.
Open the Cover AB and pulled out jammed paper and
close the Cover AB.
After this, this error will clear automatically. The
following three kinds of processing exist by the place
where jam is occurred.
In case of fuser unit; raise the pressure release lever of
the fuser unit and pulled out jammed paper
downward.
In case of second transfer unit; raise the movable
transportation guide (upper) and pulled out jammed
paper downward.
In case of jammed paper remaining in Cover AB;
Pulled out jammed paper.
Jam occurs at the optional lower cassette unit.
Open the Cover C and pulled out the jammed paper
and close Cover C.
After this, this error will clear automatically.
Jam occurs at the Duplex unit
Open the Cover DM and pulled out the jammed paper
and close Cover DM. After this, this error will clear
automatically.
Status Display (AcuLaser C1900)
UUUU TONER CART OUT (STATUS CODE: 4049~4063)
Description
Displayed when the toner cartridge indicated by uuuu is not inserted.
INSTALL PHOTOCONDCTR (STATUS CODE: 4022)
Description
The OPC drum has not been installed. Or it is not in the correct position.
Treatment method
Open the cover, install the OPC drum correctly and close the door. Then printer
will recover from the error status.
Revision B
Cover AB
Cover DM
Cover C
Front Cover
136