Epson AcuLaser C1900 Service Manual page 52

EPSON AcuLaser C1900/AcuLaser C900
Table 1-38. Function Setting (4)
Menu Item
Network Menu *1 Network I/F
Network Config
Get IPAddress *3
IP *3, *4
*3
SM
GW *3
Buffer Size
*5, *6
AUX Menu AUX I/F
AUX Config *7
Get IPAddress *8
*8, *9
IP
SM *8
GW *8
*8
NetWare
AppleTalk *8
NetBEUI *8
*10
AUX Init
Buffer Size
ESC/Page Menu *11 Auto CR
Auto FF
CR Function
LF Function
FF Function
Error Code
Avoid Error
PGI
TriColorSpace
CM Media Type
Product Description
Value
On, Off
*2
No, Yes
Panel, Auto, PING
0.0.0.0 ~ 192.168.192.168 ~ 255.255.255.255
0.0.0.0 ~ 255.255.255.0 ~ 255.255.255.255
0.0.0.0 ~ 255.255.255.255
Normal, Maximum, Minimum
On, Off
No, Yes
Panel, Auto, PING
0.0.0.0 ~ 255.255.255.255
0.0.0.0 ~ 255.255.255.255
0.0.0.0 ~ 255.255.255.255
On, Off
On, Off
On, Off
Normal, Maximum, Minimum
On, Off
On, Off
CR, CR+LF
CR+LF, LF
CR+FF, FF
Ignore, Space
Off, On
On, Off
Normal, sRGB
Off, Opt1, Opt2
Note *1: The value is reflected immediately on the Status sheet and EJL read-back, but
changed practically after a warm boot or restarting of the printer.
*2: After the printer moves to "On Line", The value is automatically updated to No.
*3: Displayed only when Network menu→Network Config=Yes
*4: Not displayed when Network menu→Get IPAddress=Auto
*5: Displayed only when the Type-B host interface is installed
*6: The value is reflected immediately to the Status sheet and EJL read-back, but
changed practically after a warm boot or restarting of the printer.
*7: Displayed only when Type-B Level 3 is installed. After the printer moves to "On
Line", The value is automatically updated to No.
*8: Displayed only when Type-B Level 3 is installed and when AUX menu→AUX
Config=Yes. The content of the setting depends on the Type-B Level 3 board setting.
The value of the setting is valid when the printer is ready to print and the network
card is started again. For this reason, when the value of the setting is changed, if
"AUX Status Sheet" of the Information menu is executed before exiting the panel
setting menu, the previous value of the setting before the change is printed.
*9: Not displayed when AUX menu → Get IPAddress=Auto
*10: Displayed only when Type-B Level 3 is installed and when AUX menu→AUX
Config=Yes
*11: Not displayed on the panel, and not included in the Status sheet either. Possible to be
set at EJL.
Control Panel
Revision B
52