Epson AcuLaser C1900 Service Manual page 138

EPSON AcuLaser C1900/AcuLaser C900
MANUAL FEED TTT (STATUS CODE: 1013)
Description
This error occurs if a printing request takes place when "Manual Feed=On" has
been specified by the command or on the panel.
Treatment method
1. Press the Start/Stop button, and the printer will perform printing by feeding paper
from the top-priority paper feeder among the feeders where paper has been set.
This error occurs only at the beginning of the job; once printing is started, the
error never occur at printing on any of the subsequent sheets of paper. However,
this error occurs again when the paper has been used up. "Check Paper Size" does
not occur even when Size Ignore = Off.
2. To cancel printing, execute "Reset" or "Reset All" or press the "Job Cancel"
button. Printing does not start even when Auto Cont = On.
CAN'T PRINT DUPLEX (STATUS CODE: 3005)
Description
If duplex printing is impossible for restrictions to duplex printing, this error occurs
before starting to print on the sheet.
Treatment method
1. Press the Start/Stop button, and the printer will recover from the error status and
start printing (simplex printing, however). If the cause of the error lies in setting of
paper feeders, changing the setting can let the printer recover from the error status
and perform duplex printing.
2. When Auto Cont = On, the printer will start simplex printing a certain time later.
3. To cancel printing, execute "Reset" or "Reset All" or press the "Job Cancel"
button.
Troubleshooting
PAPER OUT SSS TTT (STATUS CODE: 4010)
Description
This error occurs in either of the following cases:
1. There is no paper in the selected paper feeder tttt.
2. None of the paper feeders has any paper, even when there is no printing request.
When none of the paper feeders has any paper, only "Paper Out", without tttt or
sss, is displayed.
When both ttt and sss are selected automatically, neither ttt nor sss are displayed.
When ttt is selected automatically, the LCD shows, among the values for Paper
Source, the relevant value other than Auto.
Treatment method
Placing paper in the displayed paper feeder will let the printer automatically
recover from the error.
In the case of 1 above:
Place paper of size sss in the paper feeder tttt, and the printer will
automatically recover and perform printing.
In the case of 2 above:
Place paper in any paper feeder, and the printer will automatically recover
from the error status.
PAPER SET SSS TTT (STATUS CODE: 3003)
Description
If the paper size set in the selected paper feeder differs from the paper size sss
which has been set for printing, this error occurs before printing on that page. This
error does not occur when Size Ignore = On.
Treatment method
1. Place paper of size sss in the paper feeder tttt and press the Start/Stop button. Then
the printer will recover from the error status and perform printing by feeding paper
from the paper feeder ttt. Even when the paper in the paper feeder is not replaced,
paper will be fed from ttt.
2. When Auto Cont = On, the printer will resume printing a certain time later by
feeding paper from the paper feeder tttt.
3. To cancel printing, execute "Reset" or "Reset All" or press the "Job Cancel"
button.
Status Display (AcuLaser C1900)
Revision B
138