Chery QQ Service Manual page 594

Title: control of AC011 "Hydraulic unit overflow port screw plug"
(B)
Wait until the program comes to an end
Turn off the engine
Wait for one minute
Ignition (if any fault occurs, the buzzer will be started)
If the check result is OK, ET061 "Region Qualified" will be shown. If the "Region finished" or
ET063 "Electromagnetic valve is null" is shown, repeat the procedure (B).
(D) Apply all drive ratios (the information shown on the display on the instrument board should be OK)
(E) Turn off the engine
Clutch cylinder/liquid leakage during replacement of clutch sensor
(A) Ignition
Ensure no fault
(B) Open the hydraulic unit overflow port screw plug
Title: control of AC008 "The first-stage clutch pipeline overflow port"
When there is any liquid flowing out without air bubble, close the overflow screw plug
Wait until the program comes to an end (six minutes)
Title: control of AC009 "The second-stage clutch pipeline overflow port"
(C)
Wait until the program comes to an end (eight minutes)
Title: control of RZ003 "Important Attempts"
(D)
(E) Place the gearshift lever to the neutral position
Start the engine
Wait for ten seconds (used in important clutch experiments) and provide no speed.
If the check result is OK, ET062 "Important experiments finished" will be shown. Otherwise,
repeat the procedure (E)
(F) Turn off the engine
High-pressure pipeline
(A) Ignition
Ensure no fault
(B) Open the hydraulic unit overflow port screw plug
Title: control of AC008 "The first-stage clutch pipeline overflow port"
When there is any liquid flowing out without air bubble, close the overflow screw plug
Wait until the program comes to an end (six minutes)
(C) Title: control of AC009 "The second-stage clutch pipeline overflow port"
Wait until the program comes to an end (eight minutes)
Turn off the engine
PDF created with pdfFactory Pro trial version
CHERY SQR7080 EZ Drive SERVICE MANUAL
www.pdffactory.com