Inspection And Repair Of Horns; Table Typical Troubleshooting And Solutions Of Horn - Chery QQ Service Manual

Water remains after wiping
Wiper blade works well on one
side, and emits crack on the
other side
Part of surface can not be
wiped

. Inspection and Repair of Horns

Only one horn is used in Chery S11, it is installed to the inside of front left bumper beam,
the current through the horn relay contacts is supplied by F4(10A)
Typical troubleshooting and solutions thereof are shown in the table

Table Typical troubleshooting and solutions of horn

Symptom
Horn does not work
Chery QQ Service Manual
Rubber strip broken or damaged
because of being abrasion on the
edge
Rubber strip aging, surface torn
Paint, polishing agent and oil, etc left
on windshield
Wiper rubber strip is deformed and
fails to work
Locating arm is distorted and wiper
blade sideling
windshield
Wiper rubber strip is dropped out the
groove wiper blade does not contact
windshield uniformly, spring or steel
strip get bent
Wiper arm contacts with windshield
under too great pressure
Causes
Loose contact of the horn connector,
Fuse blowing out
Horn relay defective
- 107 -
BCM Computer Control System
Replace
Replace
Wiping windshield with
clean
degreaser
Replace
Carefully make the arm
gets stuck on vertical
Insert the wiper rubber
strip in the groove
Replace
Lubricate wiper lever joint
and spring or replace the
arm
Solution
Repair or replace
Replace
rag dipped in
Replace