Chery QQ Service Manual page 335

12. Remove 4 bolts and baffle and push out the bearing on the driving end.
13. If necessary, loosen stud bolts and pull out the stator.
Note: Heating the frame on the driving end may facilitate disassembling stator.
Assembling
Before disassembling evaluate the faults. After that, find out the part subject to
malfunction by means of careful check. Make available the parts for exchange use,
and then assemble the generator in the step contrary to that of disassembling.
Note:
1 When the stator coil is inserted into the frame on the driving end, the recess in
the stator should be aligned with the stud bolts.
2 When the brush carrier assembly is installed, the brush mush be thoroughly
disengaged from slip ring.
Note:
When the rectifier is installed, check whether there is an enough big gap between
stator conductor and cooling fan blade.
Avoid over -tightening the insulator nuts of terminal post.
Tightening torque of stud bolt: 7 8.8N.m,
Tightening torque of frame bolt/nut and nut in the terminal post: 4 5N.m
Chery QQ Service Manual
- 28 -
Charging System