Chery QQ Service Manual page 298

Chery QQ Service Manual
Service guide
Replace ignition switch core
Removal
1. Remove plastic cover
2. Insert needle into lock hole and pull out the
core from lock seat.
Steps of installation
1. Push the moving block to the direction
shown in the figure.
2. Insert the core into the seat.
Steering shaft replace
Disassembly procedure
1. Remove steering wheel from shaft.
Points of attention
Don't knock steering when install or remove.
2. Loosen switch cover bolts. Remove signal
switch (left) and wiper switch (right). Loosen
the bolts between up/down shaft.
3.Loosen moving bolts on steering column
under instrument cluster.
4. Remove steering column.
5. Remove up steering shaft
Points of attention
The lower guide bearing is a rubber bearing.
Carefully remove the bearing.
Don't put steering lock in lock position.
Steps of installation
1. Insert new up shaft into steering column.
Insert lower guide pipe into rubber bearing.
Push the bearing to the end.
2. Connect separate block, support, lower
support with bolts.
Use new locknuts.
Fixture
Screw support and lower support with
13-17Nm.
3. Insert shaft flange and fix. Insert harness
connector into signal switch and wiper switch.
Fix signal switch cover.
Fixture
4. Install steering wheel in steering shaft
Screw bolts with 22.5-27.5 Nm.
Screw bolts with 22.5-27.5 Nm.
Fixture
Screw steering nuts and shaft nuts with
27-33Nm.
5. Check forwards position of the steering
institution.
95
Chery Automobile Co., Ltd
Chassis System