Table of Contents
Advertisement
Chery QQ Service Manual
consequential injuries.
Remove all movable or loose parts within spreading coverage of airbag before activating
airbag.
Activate and spread the airbag with doors closed and side windows open.
Spread the airbag only in the reserved spreading area. All necessary maintenance staff must
stay at least 10 meters away from the vehicle in the front.
Never apply voltage before all preparations are done.
Cool the airbag down for at least 30 minutes before disposal of an activated airbag.
Always wear gloves and eye shield during disposal.
In case activation of airbag fails, disconnect power and wait for at least five minutes before
approaching vehicle again.
Activating Airbag before Disposal
This specification includes vehicles to be disposed of. For vehicles within warranty period,
please contact regional maintenance manager for approval or other specifications before
activation. Except for the following additional steps, activated airbags shall be disposed of
with the same method with other disassembled parts.
1. Place the activated airbag in a firm plastic bag;
2. Make sure the plastic bag is sealed;
3. Carefully wash hands after disposal of activated airbag.
Maintenance of SRS Wire Harness
Maintenance of harness connector
Warning: SRS must be shut down before any maintenance. Please refer to "Disconnecting
Airbag" part of this manual.
Plug inside SRS is made of special material to ensure the favorable conductivity of low
energy circuit, and once damaged the whole airbag wire harness assembly must be replaced.
Do not replace the connector plug with any other plugs.
Maintenance of harness
Don't try to maintain SRS system harness. Please use new harness to replace all the damaged
harness.
Attached air bag system diagram:
- 169 -
Advertisement
Table of Contents
Troubleshooting
