Chery QQ Service Manual page 462

Chery QQ Service Manual
Torque: 22 Newton-meter (225 kg-cm, 16 pound-foot)
Adjust the engine hood
Loosen the hinge bolts, and adjust the engine hood in forward, backward and vertical
directions.
Torque: 11.5 Newton-meter (115 kg-cm, 8.3 pound-feet)
Install the hood lock control assembly
1.Apply grease on the lock before parts installation.
Lay multifunctional grease on the sliding surface.
2.Install control cable of engine hood lock.
Note: Wrap the screwdriver end with adhesive tape before installation.
Prevent the screwdriver from damage the rubber seal.
(1)Push the back end of control wire through rubber seal.
(2)Push control cable block into rubber seal with screwdriver.
(3)Clench the front end of control cable onto connection box.
(4)Put the front end of control wire through the upper support of radiator.
3.Install the unfastening handle of engine hood lock
4.Check the performance of engine hood lock
Check the engine hood lock to ensure it works well. Then fasten nuts and bolts to fix
the lock.
5.Install the following parts:
(1)Head lamps
(2)Front light shield
(3)Front fender lining
(4)Front fender fillet
(5)Radiator support cover
(6)Lower cover board of engine
- 226 –Chery Automobile Co.,Ltd