Chery QQ Service Manual page 461

Chery QQ Service Manual
Remove the engine hood hinge
1.Remove the fender (refer to "Remove Fender")
2.Loosen four fixed bolts both left and right to take out the engine hood hinge.
Replace the engine hood support
1.Take the support out of engine hood
Screw out bolts, and get the support out of engine hood.
Note: Push against the engine hood with hand, and take the support out.
2.Remove the engine hood support from the body
Screw out bolts to take the support out.
3.Replace the engine hood support
Note: Be carefull when operating the absorber!
(1)There is compressed air in the absorber cylinder. Do not disassemble absorber.
(2)If replace the absorber, drill a small hole with diameter of 2.0-3.0 mm 0.079-0.118
inch on the cylinder shell to fully release compressure, then abandon it .
(3)Be careful of sputtering iron scrap when drilling the hole.
(4)Air in the cylinder is colorless, smell-less, and nontoxic.
(5)Deal with absorber carefully. Do not drop paint or oil onto the piston rod.
(6)When the absorber fully extrudes, do not turn the piston rod or cylinder.
4.Install the engine hood support
Fix the engine hood support.
- 225 –Chery Automobile Co.,Ltd