Front.panel.configuration.port - Extron electronics CrossPoint 450 Plus Series User Manual

Front panel Configuration port
N This port is hardwired for RS-232 only.
The optional 9-pin D to 2.5 mm mini jack TRS RS-232 cable, part #70-335-01
(figure 4-2), can be used for connection to the Configuration port.
1
6
9
5
9-pin D
Pin 2 Computer's RX line
Pin 3 Computer's TX line
Pin 5 Computer's signal ground
Figure 4-2 — Optional 9-pin TRS RS-232 cable
N This port is independent of the rear panel RS-232/RS-422 port and is not
affected by changes to the rear panel port's protocol. This front panel port's
protocol can be changed via SIS command control only. See the Set serial
ports parameters command in "Command/response table for IP-specific
SIS commands", later in this chapter, to configure both ports under SIS control.
CrossPoint / MAV Matrix Switchers • Programmer's Guide
6 feet
(1.8 m)
Part #70-335-01
Connection TRS Plug
Tip
Ring
Sleeve
Tip
Ring
Sleeve (Gnd)
4-3