You must specify video, audio, or both when you are creating or viewing a
configuration. This is done with the RGBHV button (CrossPoint switchers) or
Video button (MAV Plus switchers) (
g
RGBHV (CrossPoint) button or Video (MAV Plus) button — The RGBHV
(CrossPoint) or Video (MAV Plus) button has one primary function (•) and
five secondary functions (❏):
•
Selects and deselects video for a configuration that is being created or
viewed and lights green to indicate that video is available for configuring
or for viewing.
With the Enter button and Audio button, selects between front panel
❏
locks (Lock mode 2 and Lock mode 0). See "Setting the front panel locks
(Executive modes)" on page 3-52.
With the Audio button, selects between front panel locks (Lock mode 2
❏
and Lock mode 1). See "Setting the front panel locks (Executive modes)"
on page 3-52.
With the Audio button, commands the front panel system reset.
❏
See "Performing a system reset from the front panel" on page 3-53.
(CrossPoint switchers) Selects the RGB delay mode, in which you can
❏
set the RGB delay. See "Setting RGB delay (CrossPoint Switchers)" on
page 3-28.
Select the RS-232 protocol for the rear panel RS-232/RS-422 port in Serial
❏
Port Selection and Configuration mode and indicate the selection. See
"Selecting the rear panel RS-232/RS-422 port protocol and baud rate" on
page 3-54.
h
Audio button — The Audio button has one primary function (•) and five
secondary functions (❏):
•
(Audio models) Selects and deselects audio for a configuration that is
being created or viewed and lights to indicate that audio is available for
configuration or viewing.
(Audio models) Selects the Audio mode, in which you can adjust the
❏
input audio level and the output audio volume. See "Viewing and
adjusting the input audio level (audio models)" on page 3-38 and
"Viewing and adjusting the local output volume (audio models)" on
page 3-44.
With the Enter button and RGBHV/Video button, selects between front
❏
panel locks (Lock mode 2 and Lock mode 0). See "Setting the front panel
locks (Executive modes)" on page 3-52.
With the RGBHV/Video button, selects between front panel locks (Lock
❏
mode 2 and Lock mode 1). See "Setting the front panel locks (Executive
modes)" on page 3-52.
With the RGBHV/Video button, commands the front panel system reset.
❏
See "Performing a system reset from the front panel" on page 3-53.
Select the RS-422 protocol for the rear panel RS-232/RS-422 port in Serial
❏
Port Selection and Configuration mode and indicate the selection. See
"Selecting the rear panel RS-232/RS-422 port protocol and baud rate" on
page 3-54.
CrossPoint / MAV Matrix Switchers • Operation
) and Audio (
) buttons.
g
h
3-9