Performing Soft Resets - Crosspoint 450 Plus And Mav Plus 2412, 2424, 3216, And 3232 Matrix Sizes - Extron electronics CrossPoint 450 Plus Series User Manual

Operation, cont'd
Performing soft resets — CrossPoint 450 Plus and MAV Plus
2412, 2424, 3216, and 3232 matrix sizes
The whole switcher reset function is identical to the front panel system reset (see
"Performing a system reset from the front panel" on page 3-53) without requiring
you to power down the switcher. This function is also identical to the
SIS command, see chapter 4, "Programmer's Guide". System reset clears all ties
and presets, resets all audio gains to unity gain (+0dB), and resets volume to 100%
(0dB of attenuation).
N The whole switcher reset does not reset the Internet protocol (IP) settings or
The absolute reset function is identical to
"Programmer's Guide". Absolute reset performs all of the whole switcher reset
functions and clears the switcher's IP address to 192.168.254.254 and subnet mask
to 255.255.0.0.
Perform a soft reset as follows:
1.
Figure 3-83 — Whole switcher and absolute resets
2.
3-58 CrossPoint / MAV Matrix Switchers • Operation
replace user-installed firmware.
Use an Extron Tweeker or other small screwdriver to press and hold the Reset
button until the front panel RGBHV and Audio buttons blink once (reset
whole switcher) or twice (absolute reset) (figure 3-83).
Press and hold
the Reset button.
RESET
Reset whole switcher
Press and hold
the Reset button.
RESET
Absolute reset
Release the Reset button and then immediately press and release the Reset
button again. Nothing happens if the second momentary press does not occur
within 1 second.
E }
ZQQQ SIS command, see chapter 4,
Front panel I/O buttons flash once.
I / O
5 seconds
RGBHV AUDIO
Front panel I/O buttons flash twice.
I / O
10 seconds
RGBHV AUDIO
E }
ZXXX
Release, then immediately
press and release again.
RESET
Release, then immediately
press and release again.
RESET