I/O.controls - Extron electronics CrossPoint 450 Plus Series User Manual

Operation, cont'd
f
N The Esc (
I/O controls
N Throughout this chapter, the terms "RGBHV button" and "Video button" are
Primary functions
Secondary functions
Front panel
configuration
3-8 CrossPoint / MAV Matrix Switchers • Operation
Esc ( > ) button — The Esc (
secondary functions (❏):
• Cancel operations or selections in progress and reset the front panel
button indicators.
> ) button does not reset the current configuration, the RGBHV
(CrossPoint switchers) or Video (MAV Plus switchers) button and Audio
selection button, any presets, or any audio gain or attenuation or volume
settings.
• Flashes once to indicate that the escape function has been activated.
In the I/O Group mode, select group 4 and indicate the selection.
❏
See "I/O grouping" on page 3-24.
(CrossPoint switchers) Increase the RGB delay of switches to the selected
❏
output. See "Setting RGB delay (CrossPoint Switchers)" on page 3-28.
(Audio models) Increase the audio level of the selected input.
❏
See "Viewing and adjusting the input audio level (audio models)" on
page 3-38.
(Audio models) Increase the volume of the selected output.
❏
See "Viewing and adjusting the output volume (audio models)" on
page 3-44.
With the Enter, Preset, and View buttons, select Serial Port Selection and
❏
Configuration mode. See "Selecting the rear panel RS-232/RS-422 port
protocol and baud rate" on page 3-54.
Select 115200 baud for the rear panel RS-232/RS-422 port in Serial Port
❏
Selection and Configuration mode and indicate the selection. See "Selecting
the rear panel RS-232/RS-422 port protocol and baud rate" on page 3-54.
used interchangeably.
Action/
indication:
Action 1:
locks
Action 2:
RGB delay Action/
indication:
Resets Action:
Port Action/
indication:
Audio Action/
indication:
> ) button has two primary functions (•) and six
Select video.
Green when selected
RGBHV VIDEO
or
With Enter, select Lock mode 2 or toggle between
mode 0 and mode 2.
Select Lock mode 1 or toggle between mode 2 and
mode 1.
Select RGB Delay mode.
Blinks green.
Perform a system reset
Select RS-232.
Blink: selected
Select audio.
Red when selected
AUDIO
Select RS-422.
Blink: selected
Select Audio mode.
Blinks red.