Example.5:.Grouping.inputs.and.outputs - Extron electronics CrossPoint 450 Plus Series User Manual

Operation, cont'd
Example 5: Grouping inputs and outputs
In the following example, several switcher inputs and outputs are assigned to
groups. The steps show the front panel indications that result from your action.
1.
Figure 3-30 — Clear all selections
2.
Figure 3-31 — Select I/O Group mode
3.
Figure 3-32 — Select an I/O group
N I/O groups are protected when front panel lock mode 2 is selected. You can view
3-26 CrossPoint / MAV Matrix Switchers • Operation
Press and release the Esc button (figure 3-30).
Press the Esc button to clear all selections.
C O N T R O L
VIEW ESC
ENTER PRESET
The button flashes once.
To enter I/O Group mode, press and hold the Input 1 and Output 1 buttons for
approximately 2 seconds and then release the buttons (figure 3-31).
1
Press and hold
17 18 11 32
the Input 1 button
and Output 1 button.
1
17 18 11 32
Press and release the Enter button to select group 1 (figure 3-32).
Press and release the Enter button to select group 1.
The button lights to indicate the selection.
C O N T R O L
VIEW
ENTER PRESET
1 2 3
Group #
the groups in lock mode 2, but you cannot change them from the front panel. See
"Setting the front panel Locks (Executive modes)" on page 3-52.
If front panel lock mode 2 is selected and you try to perform step 4, the actions
are ignored and the Enter, RGBHV/Video, and Audio buttons flash.
I
2 5 16
N
P
U
T
S
2 seconds
O
2 5 16
U
T
P
U
T
S
ESC
4
Release the Input 1 button
and Output 1 button.
•
Ungrouped input and
output buttons light.
I
1 2 5 16
N
P
U
T
17 18 11 32
S
O
1 2 5 16
U
T
P
U
17 18 11 32
T
S