Extron electronics CrossPoint 450 Plus Series User Manual page 154

Matrix Software, cont'd
Figure 5-13 — Confirm window
13.
N Firmware upgrades using either serial port can take several minutes.
14.
5-16 CrossPoint / MAV Matrix Switchers • Matrix Software
13
If necessary, change the port number in the device port field:
• Rear panel RS-232/RS-422 port, enter 1.
• Front panel Configuration port, enter 2.
Click the OK button. The Firmware Loader reports, "This process could take
several minutes. Please wait...", then displays a status bar that shows the
progress of the upload. When the upload is complete, the Firmware Loader
reports "Unit resetting, this can take some time, please wait. ...", and then "Transfer
complete!".
When the Firmware Loader reports, "Transfer complete!", click the Exit button
on the Firmware Loader and then again on the port configuration window.
The Firmware Loader and the Matrix Switchers Control Program close.
12
13
14