Front Panel Configuration Port (Matrix Sizes Up To 1616) - Extron electronics CrossPoint 450 Plus Series Setup Manual

Installation, cont'd
h
Remote port — If desired, connect a control
system or computer to the rear panel Remote
RS-232/RS-422 port .
N Serial port defaults: RS-232, 9600 baud, no parity, 8-bit, 1
stop bit, no flow control.
RS-232
All Models 84 — 1616
Pin# Pin Function Pin
1 — Not used —
2 TX Transmit TX–
3 RX Receive RX–
4 — Not used —
5 Gnd Ground Gnd
6 — Not used —
7 — Not used RX+
Not used TX+
8 —
9 — Not used —
i
LAN port — If desired, connect a network WAN or LAN hub, a
control system, or computer to the Ethernet RJ-45 port
• Network connection
• Computer or control system connection
interface cable as a crossover cable.
N The factory default IP address is 192.168.254.254.
j
External Sync (MAV Plus) — If desired, attach an external sync
timing device to the external sync connector.
BBG 6 A
BLACK BURST/COLOR BAR
/AUDIO GENERATOR
1 3
POWER
1 KHZ AUDIO
12V
+4dBu
0.5A MAX
L 1 R ON
1 2 3 2 4
BLACKBURST/
-10dBV PAL
COLORBAR BLACKBURST
Extron OUT
Connect to
BBG 6 A
MAV Plus.
Black Burst Color Bar
Audio Generator
Terminate cable
or connect to
another device.
Figure 2-6 — External Sync connection
k
Power — Plug the switcher into a grounded AC source.
2-6 CrossPoint / MAV Matrix Switchers • Installation
Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User's Manual at www.extron.com.
5 1
9 6
RS-422
2412 — 3232
Function Pin Function
Not used TX+ Transmit +
TX– Transmit –
Transmit –
Receive – RX+ Receive +
Not used RX– Receive –
Gnd Ground
Ground
Not used — Not used
Receive + — Not used
Transmit + — Not used
Not used
Not used —
.
— Wire as a patch (straight) cable.
— Wire the
5
6
EXT
SYNC
Front Panel Configuration Port
(Matrix Sizes up to 1616)
12
CONTROL
ENTER PRESET VIEW ESC VIDEO
CONFIG
ULTRA
CROSSPOINT
ULTRA-WIDEBAND MATRIX SWITCHER
Figure 2-7 — Front panel configuration port
l
Configuration port — If desired, connect a control system
or computer to the front panel Configuration (RS-232) port.
Use an optional 9-pin D to 2.5 mm mini jack TRS RS-232
cable, part #70-335-01.
CrossPoint / MAV Matrix Switchers • Installation
Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User's Manual at www.extron.com.
I/O
AUDIO
SERIES
WITH ADSP ™
2-7