Auto Bi-D Adjustment, Acceleration/Deceleration Print Correction - Epson SC-T7000 series Service Manual

SC-T7000 series/SC-T5000 series/SC-T3000 series
4.10.7 Auto Bi-D Adjustment, acceleration/deceleration
print correction
PAPER USED
Type: Premium Glossy Photo Paper (250)
Size: The maximum paper width which can be set
EXECUTION MODE
Normal mode
PROCEDURE
1. Turn the printer ON.
2. Load the paper into the printer.
3. Start the Service Program and select
deceleration correction.
4. Select All rows adjust or 5 rows adjust and click [Run].
The adjustment pattern will be printed.
All rows adjust
C H E C K
P O I N T "All rows adjustment" results high accuracy adjustment, but it
takes a long time.
5 rows adjust
Adjustment accuracy becomes slightly lower with "5 rows
adjustment" since colors used for this adjustment are limited;
however, the adjustment time can be shorten.
5. After the pattern is printed, the printer will automatically scan the pattern and carry
out the adjustment (no manual adjustment is needed).
6. Click [Finish].
7. Turn the printer OFF to finish the adjustment.
ADJUSTMENT
Auto Bi-D adjustment, acceleration and
CR Related Adjustments
Figure 4-27. [Auto Bi-D Adjustment] Screen
Figure 4-28. Adjustment Pattern (all rows)
Figure 4-29. Adjustment Pattern (5 rows)
Revision B
242
Confidential