Pf Timing Belt - Epson SC-T7000 series Service Manual

SC-T7000 series/SC-T5000 series/SC-T3000 series

3.4.5.4 PF TIMING BELT

When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p199)
perform the specified operations including required adjustment.
1. Remove the UPPER LEFT COVER.
2. Remove the UPPER SUPPORT R COVER.
3. Remove the PANEL BOARD. (p120)
4. Remove the TOP COVER. (p85)
5. Remove the FRONT COVER. (p86)
6. Remove the LEFT UPPER COVER & LEFT ROLL COVER.
7. Remove the REAR LEFT LOWER COVER.
8. Remove the LEFT LOWER COVER.
9. Remove the PF ENCODER. (p166)
10. Remove the Tension Spring. (p163)
11. Remove the PF TIMING BELT from the pinion gear of the PF MOTOR.
12. Remove the screw, and remove the PF Shade Cover.
A) Silver M3x8 S-tite screw with built-in washer: 1 pcs
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
(p100)
(p94)
(p101)
(p104)
(p98)
Disassembly and Assembly Procedure
Pay attention to the positioning point (See
Engage the hook on the PF Shade Cover into the hole on the
Left Frame.
Inside
PF Shade Cover
PF Shade Cover
PF TIMING BELT
Pinion gear
Figure 3-121. Removing the PF Shade Cover
Revision B
Figure 3-121).
Left Frame
Hook
A
Left Frame
Positioning point
Confidential
168