Epson SC-T7000 series Service Manual page 157

SC-T7000 series/SC-T5000 series/SC-T3000 series
18. Pull out the HEAD FFC from the Ferrite Core.
19. Release the HEAD FFC from the two hooks of the Ferrite Core Holder.
Hook
Ferrite Core
Ferrite Core Holder
Figure 3-107. Removing the HEAD FFC
DISASSEMBLY & ASSEMBLY
20. Remove the two FFC clamps from the top of the CR UNIT.
21. Remove the screw that secures the FFC Shield Plate.
Hook
HEAD FFC
22. Pull out the HEAD FFC and CR FFC from the two Ferrite Cores.
Disassembly and Assembly Procedure
B) Silver M3x6 S-tite screw with built-in washer: 1 pcs
Secure the Grounding wire and the plate with the same screw
shown in the below figure.
Pay attention to the positioning points (See
Positioning points
FFC Shield Plate and
Lower FFC Sheet Guide
Carriage
Main Assy
FFC Clamps
Figure 3-108. Removing the HAED FFC and CR FFC (Top of the CR UNIT)
Revision B
Figure 3-108).
Screw
together
Grounding wire
B
Ferrite Core
CR FFC
HEAD FFC
157
Confidential