Epson SC-T7000 series Service Manual page 132

SC-T7000 series/SC-T5000 series/SC-T3000 series
15. Remove the FFC clamps.
16. Remove the screw that secures the FFC Shield Plate.
A) Silver M3x6 S-tite screw with built-in washer: 1 pcs
Secure the Grounding wire and the plate with the same screw
shown in the below figure.
Pay attention to the positioning points (See
17. Pull out the CR FFC and HEAD FFC from the two Ferrite Cores.
FFC Shield Plate and
Lower FFC Sheet Guide
Carriage
Main Assy
FFC Clamps
Figure 3-69. Removing the CR FFC (Top of the CR UNIT)
DISASSEMBLY & ASSEMBLY
Figure 3-69).
Screw
together
Positioning points
Grounding wire
A
Ferrite Core
CR FFC
HEAD FFC
Disassembly and Assembly Procedure
18. Disengage the three joints from the two each holes on the FFC Sheet Guide.
19. Remove the two FFC clamps.
FFC Sheet Guide
Figure 3-70. Releasing the FFC (1)
Revision B
Joints and holes
FFC Clamps
Confidential
132