Paper Thickness Sensor - Epson SC-T7000 series Service Manual

SC-T7000 series/SC-T5000 series/SC-T3000 series

3.4.5.11 PAPER THICKNESS SENSOR

When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p199)
perform the specified operations including required adjustment.
1. Remove the UPPER LEFT COVER.
2. Remove the UPPER SUPPORT R COVER.
3. Remove the PANEL BOARD. (p120)
4. Remove the TOP COVER. (p85)
5. Remove the RIGHT UPPER COVER & RIGHT ROLL COVER.
6. Remove the two screws, and remove the Paper Thickness Sensor Assy while
sliding in the direction of the arrow.
A) Silver M3x8 P-tite screw with built-in washer: 2 pcs
A
Figure 3-141. Removing the Paper Thickness Sensor Assy
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
(p100)
(p94)
(p95)
Paper Thickness Sensor Assy
A
Disassembly and Assembly Procedure
7. Disengage the hook, and remove the PAPER THICKNESS SENSOR.
8. Disconnect the cable from the PAPER THICKNESS SENSOR.
9. Release the cable from the hook of the Sensor Holder.
Connector
Sensor Holder
PAPER THICKNESS SENSOR
Figure 3-142. Removing the PAPER THICKNESS SENSOR
Revision B
Hooks
Hook
Hook
Connector
Cable
Confidential
180