Ricoh Printer Quick Installation Manual page 53

11. Match the controller board to the top and bottom rail using the " " mark, and then slide it
into the printer slowly until it stops.
12. Push the handle of the controller board until it clicks.
13. Fasten the controller board to the printer with the two screws.
• Use a coin or similar object if the screws do not turn easily.
• After finishing installation, you can check whether the hard disk drive is properly installed: Print the
configuration page from the [List/Test Print] menu. If it is installed properly, you will see "Hard Disk
Drive" for "Device Connection" on the configuration page.
BMU025S
BMU026S
BMU027S
Installing the Memory Expansion Units
2
35