Ricoh Printer Quick Installation Manual page 516

5. Monitoring and Configuring the Printer
add_sess_IPX: bad trap <IPX address>
community <community name>
add_sess_IPX: community <community name>
already defined.
child process exec error! (process name)
Client password rejected
5
Client tls certificate rejected
Connected DHCPv 6 Server (<DHCPv 6
serveraddress>).
Current Interface Speed: xxxMbps
DHCPv6 server not found.
IEEE 802.11 <communication mode> mode
IEEE 802.11 Card does NOT support WPA.
IEEE 802.11 Card Firmware REV.<version>
IEEE 802.11 current channel <channel number>
IEEE 802.11 MAC Address =<MAC address>
IEEE 802.11 SSID <ssid> (AP MAC Address
<MAC address>)
278
Message Problem and solutions
The IPX address (00:00:00:00:00:00) is
unavailable when the community access type is
TRAP. Specify the host IPX address for the TRAP
destination.
The same community name already exists. Use
another community name.
The network service failed to start. Turn the printer
off and then on. If this does not work, contact your
service or sales representative.
The client's password was rejected. Check the client
password.
The client's TLS certificate was rejected. Check the
certificate.
The IP address was successfully received from the
DHCPv 6 server.
Speed of the network (10Mbps, 100 Mbps, or
1Gbps).
The DHCPv6 server was not found. Make sure that
the DHCPv6 is on the network.
Displays Wireless LAN communication mode
(infrastructure, or 802.11 ad hoc).
A wireless card that does not support WPA is
installed. Install a wireless card that supports WPA.
Displays the version number of the 802.11 card's
firmware.
Displays the current channel number of the active
wireless card (in ad hoc and infrastructure mode).
Displays the MAC address of the wireless interface.
The MAC address and SSID of the access point are
connected in infrastructure mode.