Ricoh Printer Quick Installation Manual page 490

5. Monitoring and Configuring the Printer
mode {ap|802.11adhoc}
ssid "ID value"
5
channel "channel no."
key "key value" val {1|2|3|4}
keyphrase "phrase" val {1|2|3|4}
252
Parameter Value configured
You can set infrastructure mode (ap), or 802.11
ad hoc mode (802.11adhoc).
The default is infrastructure mode.
You can make settings for the SSID in the
infrastructure mode.
Usable characters are ASCII 0x20-0x7e (32
bytes).
An SSID value is set automatically to the nearest
access point if no setting is made.
If no setting is made for the ad hoc mode, the
same value as for the infrastructure mode or an
ASSID value is automatically set. The default is
blank.
You can enable or disable the WEP function. To
enable the WEP function, specify [on]; to disable
it, specify [off].
To start the WEP function, enter the correct WEP
key. The default is "11".
You can specify the WEP key when entering in
hexadecimal.
With a 64-bit WEP, you can use 10 digit
hexadecimals. With a 128-bit WEP, you can use
26 digit hexadecimals.
Up to four WEP keys can be registered. Specify
the number to be registered with "val".
When a WEP is specified by key, the WEP
specified by key phrase is overwritten.
To use this function, set the same key number and
WEP key for all ports that transmit data to each
other. Put "0x" on the front of WEP key.
You can omit the numbers with "val". The key
number is set to 1 when making these omissions.
The default is blank.
You can specify the WEP key when entering in
ASCII.