Awd Armature Plate Inspection - Polaris Sportsman 400 Service Manual

FINAL DRIVE

AWD ARMATURE PLATE INSPECTION

1. As the armature plate is engaged, it should contact
the outer magnet pole (seal sleeve) and the inner
magnet pole. Also, the armature plate must be flat
when placed on a flat surface. Bent armature plates
should be replaced.
NOTE: It is not unusual to see a double wear ring on
the armature plate; however, the wear rings should
be even.
2. Install the roller clutch (Hilliard Clutch) assembly
and be sure the armature plate (A) is positioned
properly. Also, when installing the hub assembly,
be sure the armature plate tabs remain engaged
with the roller clutch cage.
CAUTION: After the hub is installed, the slightest
movement outward with the hub may cause the
armature plate tabs to disengage from the roller clutch
cage. If the unit is driven with the armature plate out of
position, it will cause roller clutch damage.
7.10
- projex@inbox.lv -
Seal Sleeve
Armature Plate Tabs