Compaq ProLiant DL380 Setup And Installation Manual page 77

1
Figure 3-1. Locating thumbscrews on front bezel
6. Pull the server out from the rack.
IMPORTANT: It is not necessary to remove the server completely from the rack.
7. On the front of the unit, loosen the three thumbscrews that secure the
server access panel.
8. Slide the server access panel toward the rear of the unit about 1 inch
(2.5 cm) and remove the access panel.
Figure 3-2. Loosening thumbscrews and removing the server access panel
Installing Hardware Options 3-3
1