Use the following procedure to connect the power cord and peripheral cables:
1. Plug cables into the server.
Figure 2-26. Cabling through the cable management arm and cable support
2. Plug the power cords into the server. Make a small loop in each power
supply cable and secure the loop as a strain relief to the location below
the power supply. This action prevents accidental removal of power
cords when the server slides in and out of the rack.
Figure 2-27. Securing the power supply power cord cable
3. Bundle all of the cables, including the power cable, and tie them to the
cable management arm.
Installing the ProLiant DL380 Server 2-31