Compaq ProLiant DL380 Setup And Installation Manual page 58

3. Secure the back end of the mounting bracket assembly to the back
corner brace of the rack with one M6 x 1.0-12L Phillips screw through
the bottom hole of the left side of the bracket and the cage nut and one
screw through the bottom hole of the right side of the bracket and cage
nut, as shown.
Figure 2-14. Attaching the back of mounting bracket assembly to the rack
(left view)
NOTE: The screw holes on rear of the brackets are oval holes.
Figure 2-15. Attaching the back of the mounting bracket assembly to the rack
(right view)
4. After attaching both of the mounting bracket assemblies to the rack,
prepare the server for mounting into the rack.
Installing the ProLiant DL380 Server 2-21