Compaq ProLiant DL380 Setup And Installation Manual page 62

2. Carefully align the server component rails with the rack slide rails, as
shown in the following figure.
Figure 2-19. Aligning the server component rails with the rack rails
3. Ensure that the server component rails are fully engaged into the plastic
guides and bearings on the rack rails on both sides, then slowly slide the
server into the rack. The server slides forward until the release latches
engage the rack rails.
WARNING: To reduce the risk of personal injury, be careful when pressing the
server rail release latches and sliding the component into the rack. The slide
rails could pinch your fingertips.
CAUTION: Be sure to keep the server parallel to the floor when sliding the
server rails into the slide rails. Tilting the server up or down could result in
damage to the rails.
Installing the ProLiant DL380 Server 2-25