Compaq ProLiant DL380 Setup And Installation Manual page 51

2-14 Compaq ProLiant DL380 Setup and Installation Guide
Also, the front of the rack-mount bracket can be identified by the round
threaded holes; the rear of the rack-mount bracket has oval holes.
Figure 2-8. Positioning the rack-mounting bracket for installation of the outer
bracket rail
To attach the outer bracket rails to the rack-mounting bracket, complete the
following steps while referring to the following figure:
1. Lay the outer bracket rails inside the rack-mounting brackets along the
inside edge of the rack-mounting bracket. The front of both pieces
(rack-mount bracket and outer bracket rails) should be oriented in the
same direction.
2. Fully extend the inner slides from the front of each outer bracket rail 1.
With these pieces extended, a screw hole toward the rear aligns in the
rack-mounting bracket and the outer bracket rail for each assembly.
3. Fasten the outer bracket rail to the rack-mounting bracket with an 8-
32 x ¼-inch slotted screw. Refer to Figure 2-9, Step 2.
IMPORTANT: Do not tighten screws until all three screws have been lined up on each
assembly. (Do not use nuts or washers with the screw.)
4. Repeat Step 3 for the second assembly.
5. Push in the inner slide on each set 3 until only 1 1/2-inches of the slide
remains extended. Push in the locking clip on the slide if it keeps the rail
from sliding in. This allows access to the next screw hole. The hole is
toward the front of the outer bracket and aligns through the outer bracket
rail and the rack-mounting bracket.