Compaq ProLiant DL380 Setup And Installation Manual page 52

6. Use one more 8-32 x ¼-inch slotted screw to fasten the outer bracket rail
to the rack-mounting bracket 4. See Figure 2-9.
7. Refer to Figure 2-9 and repeat Steps 1 through 4 for the second
assembly.
8. Fully extend the inner slides from the front of each outer bracket rail.
9. Fully extend toward the front the ball-bearing slide located in the inner
slide 5. With these pieces extended, a screw hole toward the center
aligns in the rack-mounting bracket and the outer bracket rail for each
assembly.
10. Fasten the outer bracket rail to the rack-mounting bracket with an
8-32 x ¼-inch slotted screw. Do not use nuts or washers with the screw.
Refer to Figure 2-9, Step 6.
11. Repeat the procedure for the second assembly.
IMPORTANT: The outer bracket rails must be mounted on the inside holes of
the rack mounting bracket or the server will sit too high in the rack.
Installing the ProLiant DL380 Server 2-15