2. Remove the server access panel.
3. Remove the 1.44-MB diskette drive. See "Replacing the 1.44-MB
Diskette Drive" for details.
4. Use a narrow instrument to release each clip from the bezel 1 and 2 by
pushing inward slightly, as shown in the following figure.
5. Once each clip is disengaged, remove the switch parts from the bezel,
collecting the two plastic parts and the spring as they disengage from the
bezel. Use care because the tension in the spring may cause it to come
loose.
Figure 3-32. Inserting the power switch into the front bezel
6. Rotate the switch assembly 180 degrees 1 as shown in the following
figure.
2
1
Installing Hardware Options 3-29