Station Message Detail Recording (Smdr) - Comdial DX-80 Installation & Maintenance Manual

¢£¤¥
•
Use and the
•
Use the conventions above to program other speed dial numbers.
•
When all changes are made press the ESC (escape) key to exit this database-programming screen. You will
see the prompt: "Exit This Feature"; press "Y" for yes.
•
You will then be prompted to "Save Current Setting?"
•
Press "N" to abort changes and leave all data unchanged.
•
Press "Y" to save changes.
•
If you press "Y" (yes), you will then be prompted "File Exists, Override?"
•
Press "N" to abort changes and leave all data unchanged.
•
Press "Y" (yes) to continue with the save operation.
To program Individual SPD Numbers:
¢£¤¥
•
Use to highlight Individual SPD No. then press
•
Input the extension directory number for which changes are to be made, then press
¢£¤¥
•
Use and the
«
•
Press .
•
Input the new telephone number with special characters as required.
•
Pause = "P"
•
Flash = "/" (forward slash button)
•
Speed Numbering Chaining = "@" + next speed number (470-489).
«
•
Press .
•
Use the cursor arrows and the
•
Use the conventions above to program other speed dial numbers.
•
When all changes are made press the ESC (escape) key to exit this database-programming screen.
You will see the prompt: "Exit This Feature"; press "Y" for yes.
•
You will then be prompted to "Save Current Setting?"
Ø Press "N" to abort changes and leave all data unchanged.
Ø Press "Y" to save changes.
•
If you press "Y" (yes), you will then be prompted "File Exists, Override?"
Ø Press "N" to abort changes and leave all data unchanged.
Ø Press "Y" (yes) to continue with the save operation.
°
•
Press (escape) again to return to the Database Programming menu.
•
Continue making other programming changes or exit PC-DBA programming.
Note: Changes made via PC-DBA are not updated to the DX-80 system memory until a "SEND" function
has been performed. Please refer to the Programming section of this manual to learn more about this
procedure.

Station Message Detail Recording (SMDR)

This feature allows the system administration to track all incoming and outgoing CO line traffic, chronologically by
extension number. Account code data is output for each call record when entered to place a call. SMDR is output
from the standard "SMDR" RS232 serial port located on the CPM (Central Processor Module). An external serial
printer or call accounting device may be connected for permanent record keeping or call cost accounting. Each data
record is output within the standard 80-character frame. Data communications is one direction only through the
SMDR port and is programmable for data rate (baud rate) in database programming.
P7290 IMM
DX-80 I M
NSTALLATION AND AINTENANCE
³´
buttons to select the System Speed Dial number to change.
³´
buttons to select the Speed Dial number to change.
³´
buttons to select the System Speed Dial number to change.
3-221
M
ANUAL
«
.
«
.