Task 7: Enable The Ftp Server On The E-Series Router; Task 8: Identify The Files To Transfer; Task 9: Transfer Files To The User Space; Task 10: Install Files On The System Space - Juniper E-Series Installation And User Manual

B-6 APPENDIX B
Installing JUNOSe Software
If the E-series router cannot reach the network host, verify that you
performed the previous steps in this procedure correctly and that the
network host is operational.

Task 7: Enable the FTP Server on the E-Series Router

The E-series router divides its vty resources among Telnet, SSH, and FTP
services. Each FTP session requires one vty line, and the FTP service uses
the authentication method configured for the vty line. If you configured
more than one vty line for Telnet access, the FTP service will use one of
those lines. If you configured only one line for Telnet access, configure
another vty line. See Chapter 8, Accessing E-Series
To enable the FTP server, use the ftp-server enable command.
host1(config)#ftp-server enable

Task 8: Identify the Files to Transfer

To identify all the files for the release, open the software release (.rel) file
on the E-series software CD with a text editor. The software release file
contains a list of all the files associated with the release. You must transfer
the software release file and all the files it contains to the user space.

Task 9: Transfer Files to the User Space

To transfer the files for the release to the E-series user space, use the FTP
client software on the network host to connect to the FTP server on the
E-series router. Transfer the files to a subdirectory within the incoming
directory. If you specify a subdirectory that does not exist, the E-series
router creates the directory.
Note: Be sure to transfer the software release file and all the files it lists.

Task 10: Install Files on the System Space

Installing the software release file to the system space installs all files listed
in the software release file. To install the software release file from the
incoming directory in the E-series user space to the E-series router space,
use the copy command.
Note: The destination file must have a .rel extension.
For example:
host1#copy /incoming/releases/x-y-z.rel x-y-z.rel
Routers.