Snmp; The Next Step - Juniper E-Series Installation And User Manual

8-6 CHAPTER 8
Accessing E-Series Routers

SNMP

The Next Step

The system is now in Global Configuration mode, from which you
can configure the system. See
Guide, Chapter 2, Command Line
Caution: Do not change the IP address for the Ethernet interface that you are
using to communicate with the system. If you change the address, you will lose the
Telnet session.
The system supports Simple Network Management Protocol (SNMP), a
standard management protocol for IP networks. You can configure the
system as an SNMP agent.
As an SNMP agent, the system provides access to management
information that it maintains. See
Guide, Chapter 3, Configuring SNMP
E-Series Command Reference Guide A to M
Reference Guide N to Z
configuring the system as an SNMP agent.
Turn to Chapter 9, Maintaining E-Series
E-Series System Basics Configuration
Interface.
E-Series System Basics Configuration
for information on SNMP. See
and
for the commands that are available for
Routers.
E-Series Command