Erx-7Xx Models - Juniper E-Series Installation And User Manual

1-6 CHAPTER 1
E-Series Overview

ERX-7xx Models

Figure 1-5 ERX-14xx model, rear view
Note: In the E-series documentation, the term ERX-7xx models refers to both the
ERX-705 router and the ERX-710 router. The terms ERX-705 router and ERX-710
router refer to the specific models. See
The ERX-7xx models are robust, high-density routers with less capacity
than the ERX-14xx models. The ERX-7xx models use either the
SRP-10G module or the SRP-5G module.
You can configure the ERX-7xx models to enable the line modules to
operate either at full line rate performance or at a rate dependent on the
resources available. For information about configuring performance of
line modules, see E-Series System Basics Configuration Guide,
Chapter 5, Managing Line Modules and SRP
Note: The 10-Gbps SRP module used in the ERX-310 router is different from the
10-Gbps SRP module used in the ERX-710 router. See section
in this chapter, for more information.
Figure 1-6 and Figure 1-7.
Modules.
SRP Module, later