Juniper E-Series Installation And User Manual page 69

Œ


Œ
Figure 5-5 Ejectors in the open position
6
Slide the module into the chassis by placing it between the guides of
the selected slot and pushing the module until it stops.
The module stops sliding when the ejectors make contact with the
front of the chassis.
Caution: If you meet strong resistance when attempting to seat the module using
the ejectors, remove it from the chassis and confirm that the slot is one designed to
hold the module. Also, be sure that you have aligned the top and bottom edges in
the correct matching tracks.
7
Insert the module into the backplane by simultaneously depressing
both ejectors (as shown in
on the module.
Installing SRP I/O and SRP Modules
Figure 5-5) and exerting forward pressure
5-9
E-Series Routers