Task 6: Mount The Cd On The Network Host; Task 7: Copy The Software Release File; Task 8: Save The Current Configuration - Juniper E-Series Installation And User Manual

host1#configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#host hostName ipAddress ftp loginname password
7
Press <CTRL-Z> to return to Privileged Exec mode.
8
Use the ping command to determine whether the E-series router
can now reach the network host.
host1#ping hostname
If the E-series router cannot reach the network host, verify that you
performed the previous steps in this procedure correctly and that the
network host is operational.

Task 6: Mount the CD on the Network Host

The way you mount the CD on the network host depends on the type of
network host you use, the operating system, and the way your network is
configured. To find out how to mount a CD on the network host, review
the manual for the operating system, or check with your network
administrator.

Task 7: Copy the Software Release File

To copy the software release file to the E-series router, use the copy
command.
Note: The destination file must have a .rel extension.
For example:
host1#copy hostname:/cdrom/x-y-z/x-y-z.rel x-y-z.rel
The software release will be copied from the network host to the
E-series router. This process can take several minutes.

Task 8: Save the Current Configuration

To save the current configuration, use the copy running-configuration
command:
host1#copy running-configuration filename.cnf
Installing Software When a Firewall Does Not Exist B-11
E-Series Routers