Removing The Fan Tray - Juniper E-Series Installation And User Manual

9-14 CHAPTER 9
Maintaining E-Series Routers
Figure 9-8 Fan tray in ERX-310 router

Removing the Fan Tray

To remove the fan tray:
1
(ERX-14xx models only) Place a flathead screwdriver in the groove
where the top bezel meets the chassis on the top of the system, and
lever the top bezel off the front of the system.
2
With an appropriate screwdriver, loosen the captive screws located at
the corners of the fan tray.
Warning: Do not place your fingers near the fans when removing the fan tray. The
blades may still be moving.
3
Pull the fan tray halfway out of the shelf.
Warning: Slowly slide the fan tray out of the chassis. The tray does not have stops
to prevent it from sliding all the way out.
4
Pull the tray out of the chassis.