Task 4: Assign An Ip Address; Task 5: Configure Access To The Network Host; Task 6: Mount The Cd On The Network Host; Task 7: Copy The Software Release File - Juniper E-Series Installation And User Manual

B-14 APPENDIX B
Installing JUNOSe Software
Note: If you do not press the key sequence <mb> before the countdown ends, the
reloading process continues and returns the CLI to the normal User Exec mode.

Task 4: Assign an IP Address

When you assign an IP address to the E-series router in Boot mode, the
address is configured on the Fast Ethernet port of the primary SRP
module. To assign an Internet address to the E-series router, use the ip
address command.
:boot##ip address ipAddress [ mask ]

Task 5: Configure Access to the Network Host

To configure access to the network host:
1
Configure a gateway through which the E-series router will reach the
network host.
:boot##ip gateway ipAddress
2
Determine whether the E-series router has been configured to
recognize the network host.
:boot##show host
If the network host is listed, go to the next section. Otherwise,
proceed with step 3.
3
Add an entry to the Static Host Table so that the E-series router can
access the network host.
:boot##host hostName ipAddress ftp login-name password
The host command allows you to specify the network host name and
IP address.

Task 6: Mount the CD on the Network Host

The way you mount the CD on the network host depends on the type of
network host you use, the operating system, and the way your network is
configured. To find out how to mount a CD on the network host, review
the manual for the operating system, or check with your network
administrator.

Task 7: Copy the Software Release File

To copy the software release file to the E-series router, use the copy
command.
Note: The destination file must have a .rel extension.