Honda EP3 Service Manual page 1099

sRs
DTC Troubleshooting (cont'd)
6. Reconnectthe battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 3-3 indicated?
YES-Go to step L
NO-Shon in the driver's seat belt tensioner;
replace the driver's seat belt (see page 23-4).1
L Turn the ignition switch OFF. Disconnectthe
battery negative cable, and wait for 3 minutes.
10. Disconnect floor wire harness 4P connector C403
(A)from dashboard wire harness B.
07sAz-TB4or 1A
Connectthe SRS inflator simulator (2 Q
connectors) and simulator lead F to dashboard wire
harness B.
Reconnect the battery negative cable.
Erase the DTC memory.
Read the DTC.
ls DTC 3-3 indicated?
YES-Go to step 15.
NO Short in the floor wire harness; replace the
floor wire harness.l
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
1 1 .
1 3 .
1 4 .
23-50
t J
16. Disconnect the driver's airbag connector (see step
2 on page 23-211,lront passenger's airbag
connector (see step 3 on page 23-21), and front
passenger's seat belt tensioner connector (see step
5 on page 23-22).
1 7 . D i s c o n n e c t S R S u n i t c o n n e c t o r A ( 1 8 P ) f r o m t h e
SRS unit (see step 7 on page 23-22:,.
18. Disconnect the special tool from dashboard wire
harness B.
1 9 . C h e c k r e s i s t a n c e b e t w e e n t h e N o . 8 t e r m i n a l a n d
t h e N o . 1 7 t e r m i n a l o f S R S u n i t c o n n e c t o r A ( ' l 8 P ) .
There should be an open circuit, or at least 1 l\4 Q .
SRS UNIT CONNECTOR A I18P)
W i r e s i d e o f f e m a l e t e r m i n a l s
ls the resistance as specif ied?
YES Faulty SRS unit; replace the SRS unit (see
page 23-1221.a
N O - S h o r t i n d a s h b o a r d w i r e h a r n e s s B ; r e p l a c e
d a s h b o a r d w i r e h a r n e s s B . l
L J
RED/WHT
RED/BLU