Driver's Airbag Replacement - Honda EP3 Service Manual

A
\'l9
Driver's Airbag Replacement
Removal
1. Disconnectthe battery negative cable, and wait at
least 3 minutes before beginning work.
2. Remove the access panel (A) from the steering
wheel, then disconnect the driver's airbag 4p
connector (B)from the cable reel.
Remove the maintenance cover (A), then remove
the two Torx bolts (B) using a Torx T3O bit.
Disconnect the horn switch connector (1P) (D).
Remove the driver's airbag (C).
5 .
l f c
23-113
Installation
1. Connect lhe horn switch connector (1P) to the
driver's airbag.
2. Place the new driver's airbag (A) inthesteering
wheel, and secure it with new Torx bohs (B), and
installthe maintenance cover (C).
a
9.8 N.m {1.0 kgf.m, 7.2 lbt.ft)
Connect the cable reel to the driver's airbag 4P
connector (A), then installthe access panel (B) on
the steering wheel.
Connect the battery negative cable.
After installing the airbag, confirm proper system
o p e r a t i o n :
. T u r n t h e i g n i t i o n s w i t c h O N ( l l ) ; t h e S R S i n d i c a t o r
should come on for about 6 seconds and then go
off.
. Make sure the horn works.
4.
5 .