Honda EP3 Service Manual page 1116

t
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 22-4 indicated?
YES Go to step g.
NO-Short to power in the front passenger,s seat
belt buckle tensioner; replace the front passenger,s
seat belt buckle. !
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes,
1 0 .
Disconnect both side airbag 2P connectors (see
s t e p 4 o n p a g e 2 3 - 2 1 ) a n d t h e d r i v e r ' s s e a t b e l t
buckle tensioner 4P connector (see step 6 on page
,1_r'>\
Disconnect SRS unit connector B (18P) from the
SRS unit (see step 7 on page 23-221.
Disconnect the special tool from the floor wire
harness.
Reconnect the battery negative cable.
Turn the ignition switch ON (ll).
Check for voltage between the No. 2 terminal of
S R S u n i t c o n n e c t o r B { 1 8 P ) a n d b o d y g r o u n d , a n d
t h e N o . 1 1 t e r m i n a l a n d b o d y g r o u n d . T h e r e s h o u l d
b e 0 . 5 V o r I e s s .
SRS UNIT CONNECTOR
B I18P)
ls the voltage as specified?
Y E S - F a u l t y S R S u n i t ; r e p l a c e t h e S R S u n i t ( s e e
page 23-1221 .l
NO Short to power in the floor wire harness;
replace the floor wire harness.l
1 1 .
' t 2 .
t 5 .
1 4 .
23-67