Panasonic KX-UDS124 Administrator's Manual page 279

Password for Web User Interface Programming
Problem
I have lost the login password of the Web
user interface for the Administrator or User
account.
Time
Problem
The time is not correct.
Checking the Status of the SIP-CS
You can check the status of the SIP-CS by using Web user interface programming (® see 2.2.2 Network
Status and 2.2.6 PS VoIP Status) or by looking at system logs (® see 4.2.3 Syslog Settings) sent from the
SIP-CS.
To check the setting status in the Web user interface
1.
Click the [Status] tab, and then click [Network Status] to check the network settings.
2.
Check the status displayed.
3.
Click [PS VoIP Status] to check the VoIP settings.
4.
Click a numbered tab to check the status of the desired S-PS.
To send the system logs of specified events to the syslog server
1.
Set the following parameters to specify your PC (Windows operating system, etc.) as the syslog server:
–
SYSLOG_ADDR: Specifies the IP address or FQDN of the syslog server.
–
SYSLOG_PORT: Specifies the port number of the syslog server.
2.
Set the following parameters to log specific events:
–
SYSLOG_EVENT_SIP: Logs SIP-related syslog events.
–
SYSLOG_EVENT_CFG: Logs syslog events regarding configuration.
–
SYSLOG_EVENT_VOIP: Logs syslog events regarding VoIP operation.
Document Version 2013-03
•
Reset the password from the SIP-CS. The passwords for
both Administrator and User will be reset (® see
Section 9 Resetting to Factory Default).
For security reasons, it is recommended that the
passwords are set again immediately (® see
2.4.2 Administrator Password).
•
In the Web user interface, you can set NTP
synchronization and DST (Summer Time) control to adjust
the time automatically (® see 2.4.6 Time Adjust
Settings).
•
If the time is still incorrect even after setting NTP
synchronization, check the firewall and port forwarding
settings on the router.
10.1 Troubleshooting
Cause/Solution
Cause/Solution
Administrator Guide 279